Sony DWM02/14 Product Information page 27

NT Mode Features
In NT mode, transmitters and receivers communicate via the Remote Control Unit RMU-01 connected to a
network. This enhances convenience during simultaneous multi-channel operation.
In ST mode, a paired receiver and transmitter operate in a one-on-one configuration. This will lead to channel
congestion when the equipment count increases. In NT mode on the other hand, the transmitter and receiver
communicate via the RMU-01. Because the RMU-01 controls the overall communication volume on the remote
control channels, congestion can be avoided also when equipment count increases.
Features of Remote Control Unit RMU-01
Connection to receiver is established via Ethernet (wired LAN).
By installing the Wireless Studio application (supplied with DWR-R01D) on a computer and connecting this
computer to the network, multiple transmitters can be monitored and controlled from the computer.
Connection diagram (simplified)
Computer used for monitoring
General communication flow
In NT mode, the receiver and transmitter communicate via the RMU-01, as shown below.
Communication flow from DWR-R01D
Computer used for monitoring
Hub
Receiver
Up to 41 units can be connected
RMU-01
Hub
 Send command
via Ethernet
Receiver
RMU-01
Up to 9 units can be
connected
 Transmit control command
via 2.4 GHz band
Transmitter
 ATT 0 dB
 Send information
 Receive command and
as metadata via
UFH band
 Show transmitter information
ATT 0 dB
 Change transmitter attenuation to 3 dB
 Update transmitter information
ATT 3 dB
Cross Remote Features
change ATT to 3 dB
27