Step 1 Network Setup - Sony DWM02/14 Product Information

Configuring a DWX System

Step 1 Network Setup

Specify the IP addresses and subnet masks of the devices connected to the network.
Network configuration
Configure a dedicated network for the DWX system, using 100Base-TX/10Base-T Ethernet equipment.
Do not use an existing network.
System precautions and limitations


IP address setup
IP addresses must be configured for the computer, DWR-R01D, and RMU-01.
The IP addresses should be unique within the same subnet.
The values for the first three sets of numbers are identical for IP addresses (XXX.XXX.XXX.XXX) within the
same subnet.
Example:


If IP addresses within different subnets are configured for the devices, the devices will not communicate
properly even when connected to the same hub.
Configure identical values for the first three sets of numbers as follows, and configure a unique value
between 1 and 255 in the fourth set for each device.
Configuration example:
Computer: 192.168.0.10
DWR-R01D: 192.168.0.100
RMU-01:
Set the subnet mask to 255.255.255.0.
The DWR-R01D and RMU-01 do not include a DHCP client function. Each device must have a fixed IP
address. If there is an IP address conflict due to identical addresses, the system will not operate properly.
Make sure that each device has a unique IP address.
66
Making and Checking Network Settings
Make sure that IP addresses of equipment do not conflict.
Operation is not guaranteed for connections utilizing wireless LAN access points.
For IP addresses in the same subnet
192.168.0.100 and 192.168.0.20
Values for first three sets of numbers are identical.
For IP addresses in different subnets
192.168.0.100 and 192.168.2.200
Values for first three sets of numbers are different.
192.168.0.200
Note