Table of Contents
Advertisement
Features of Wireless Studio
Using the Wireless Studio software application supplied with the Digital Wireless Receiver DWR-R01D, up to 82
transmitters can be simultaneously monitored and controlled. By recording the operation log, operational
errors can be examined later.
Information displayed in Status Viewer
Reception channel information (group/channel/frequency)
Reception data quality
Audio signal level
Transmitter RF power setting
Synchronization status of output signal at DIGITAL OUT connector of DWR-R01D
Transmitter communication status
Transmitter battery status
Transmitter name
RF input level
Setup file
Settings required for monitoring with the Wireless Studio application can be saved in a setup file and recalled
later.
Note
Wireless Studio identifies the DWR-R01D and RMU-01 by IP address. The DWM-01/DWT-B01 are mutually identified
by the DWR-R01D and MAC address. In order to allow later reloading and 100% restoring of setting information
saved in Wireless Studio, all equipment must be the same, and IP address settings also must match. If a
piece of equipment is replaced for repairs, for example, be sure to configure the same IP address for the
replacement equipment.
Log file
The log begins recording as soon as Wireless Studio enters online mode and is saved automatically in CSV
format.
You can view the contents of a saved log by using a text editor to open the log file stored in the Start > My
Documents > Wireless Studio folder.
Device List
Warning and error messages are shown here.
Status Viewer
Shows the status of various equipment.
29
Cross Remote Features
Advertisement
Table of Contents
