Sony DWM02/14 Product Information page 39

Wall installation
1
Wood screw
(supplied)
Coaxlal cable
2
Hangers
M3 screws (supplied)
to the BNC
connecter
M3 screw
Antenna seat
UHF Antenna Divider WD-850
This is a 1U size rack mount antenna divider.
 Incorporates two circuits for supplying the antenna output
to a maximum of four outputs, making it easy to configure
a diversity reception system for simultaneous multi-channel
operation.
 Provides antenna signal cascading outputs, allowing two units
to be cascaded for connection of up to eight outputs.
 9 or 12 V DC power supply output for booster amplifier.
Screw to the
wall.
Attachment B (supplied)
Attachment
B screwed to
the wall
Coaxlal
cable
Attachment
A (supplied)
Connect to the ANTENNA A/B IN
(DC9V OUT) connector on either
of the devices.
Front panel
 ANTENNA A DC OUT (power supply to antenna A) switch
Supplies 9V DC to the Sony UHF antenna connected to the
ANTENA A DC OUT 1 and 2 connectors. If interference or
distortion occurs, set to OFF.
 ANTENNA B DC OUT (power supply to antenna B) switch
Supplies 9V DC to the Sony UHF antenna connected to the
ANTENA B DC OUT 1 and 2 connectors. If interference or distortion
occurs, set to OFF.
Rear panel
  
 ANTENNA A IN / DC OUT 1 and 2 (antenna A input/DC power
output 1 and 2) connectors
When connected by coaxial cable, the signal is input from the
Sony UHF antenna while power is supplied to the antenna's
booster amplifier. The power supply can be set to 9V or OFF using
the ANTENNA A DC OUT switch on the front panel. Depending
on the required range of the wireless microphone, up to two
antennas can be connected.
 ANTENNA A CASCADE connector
During use of two dividers at the same time, connect this
connector to the ANTENNA A IN/DC OUT connector 1
or 2 on the second divider.
 ANTENNA A OUT 1 to 4 (antenna A output 1 to 4) connectors
Connect from ANTENNA A OUT connector on the unit to the
ANTENNA A IN connector on the tuner.
 ANTENNA B IN / DC OUT 1 and 2 (antenna B input/DC power
output 1 and 2) connectors
When connected by coaxial cable, the signal is input from the
Sony UHF antenna while power is supplied to the antenna's
booster amplifier. The power supply can be set to 9V or OFF using
the ANTENNA B DC OUT switch on the front panel. Depending
on the required range of the wireless microphone, up to two
antennas can be connected.
 ANTENNA B CASCADE connector
During use of two dividers at the same time, connect this
connector to the ANTENNA B IN/DC OUT connector 1 or 2 on the
second divider.
 ANTENNA B OUT 1 to 4 (antenna B output 1 to 4) connectors
Connect from ANTENNA B OUT connector on the unit to the
ANTENNA B IN connector on the tuner.
 
  
UHF System Configuration
39