Transmitter Settings; Configuring The Transmitting Channel Settings; Channel Display - Sony DWZ-B30GB Operating Instructions Manual

Transmitter
Settings
Configuring the
Transmitting Channel
Settings
Two RF modes (channel modes), wide band
and narrow band, are available on the
DWZ.
Each RF mode consists of six channels.
Select the appropriate channel according to
your intended use.
RF mode Transmitting
channel
number
Wide band 1/2/3/4/5/6
(WIDE)
Narrow a/b/c/d/e/f
band
(NARROW)
Caution
When using multiple channels (up to six),
the two RF modes, wide band and narrow
32

Transmitter Settings

band, cannot be used simultaneously. Select
only one RF mode during use.
Selecting the RF mode
1
2
3
4
Description
Selecting the channel
1
This mode
reduces any
interference
to other
2
wireless
equipment.
3
This mode
uses the
Clear
Channel
Scan
Caution
function,
If you change the channel setting on the
making it
transmitter, be sure to change the channel
useful for
setting on the receiver to the same channel.
avoiding
any
If the receiver channel and transmitter
interference
channel are not identical, audio will not be
from other
output.
wireless
equipment.

Channel Display

Each channel will appear as follows in the
transmitter's channel display.
Press and hold the POWER/MUTING
button to turn off the unit.
Press and hold the POWER/MUTING
button (about 1 second) while holding
down the channel selection button.
"0" blinks in the channel display.
Press the channel selection button to
select "1" or "a."
Press the POWER/MUTING button.
Press and hold the channel selection
button while the unit is turned on.
The channel display blinks.
Press the channel selection button to
select the channel.
Press and hold the channel selection
button to apply the channel selection.