Planar WeatherBright LC3251 Product Manual page 27

Function Function Default
Type Value
Product Get
Display ID Set 00
Runtime Get
Backlight Set/Get
Runtime
Backlight Execute
Runtime Reset
Reset Execute
Factory Reset Execute
Status Get
Status Reset Execute
Fan Control Set Auto
Main Fan Set/Get 50
Speed
Description
Returns Display ID, Model, Unit Serial Number, Date of
Manufacture, Part Number, Master Board Firmware
Version.
Sets displays identification number
Reports the runtime of the unit
Reports the runtime of the backlight.
Resets the backlight runtime
Hardware reset, all adjustable parameters remain
unchanged.
Display restores all adjustable parameters back to the
factory settings.
Returns operational status of display (OK or Alarm) and any
alarm or failure flags.
Resets fan status register
Set or read fan control status. Turn fans full ON/OFF set to
manual speed control or place in auto mode. Note: Fans will
default to auto mode on power up.
Set the speed of the main cooling fans when they are in
manual mode
LC3251 / LC4751 Product Manual
ASCII Command Value/
Range
ST product
ST display.id 00-ZZ
OP runtime
OP backlight.runtime
OP backlight.runtime.reset
OP hardware.reset
OP data.reset
ST status
OP status.reset
OP fan.control AUTO
ON
OFF
MANUAL
OP main.fan.speed 20-100
Possible Responses
Display ID: XX[CR]
Model: XXXXXX[CR]
Serial Number: XXXXXXXXX[CR]
Date of manufacture: XX-XX-XXXX[CR]
Part number: XXX-XXXX-XX[CR]
Master board firmware[CR]
version: X.XX.XX[CR]
Display ID set to XX[CR]
XX = Display ID
Days: XXX [CR]
Hours: XXX [CR]
Minutes: XXX [CR]
XXX = Time
Days: XXX [CR]
Hours: XXX [CR]
Minutes: XXX [CR]
XXX = Time
Days: 0 [CR]
Hours: 0 [CR]
Minutes: 0 [CR]
System resetting... [CR]
Adjustable parameters reset[CR]
No faults[CR]
Faults: 0xXX, 0xXX, 0xXX ...[CR]
XX = fault code, see table 1.3.1 of fault
codes for possible values.
The number of fault codes returned could
be anywhere from 1 to 19
Faults cleared[CR]
Fans AUTO[CR]
Fans ON[CR]
Fans OFF[CR]
Fans MANUAL[CR]
Main cooling fan speed set to XXX[CR]
XXX = Fan speed 20-100
27