Securing The Oven - Kenmore 30" Built In Wall Oven Installation Instructions Manual

Installation Instructions
Securing the Oven
With the conduit connected, the oven
is ready to be slid into the cutout
opening.
a. Loop a 36" string around the conduit
before the oven is slid into place. This
will keep the conduit from falling be-
hind the oven.
Pull out on
<i • string loop
while pushing
the oven into
the cabinet
II
b. Lift oven into cabinet cutout using the
oven opening as an grip. Carefully
push against oven front frame. Do not
push against outside edges.
c. As you slide the oven back, pull the
string so that the conduit will lie on top
of the oven in a natural loop.
d. When you are sure the conduit is out
of the way, slide the oven all the way
back into the opening. Remove the
string.
_-] Drill four-I/8" pilot holes through the
mounting holes (top and bottom) of the
side trim, for the four #8 screws
provided. Drill eight holes for the
Double Oven.
MOUNTING
HOLE
_,/ LOCATIONS _
JFF_IlIIY_
The screws must be a
minimum of 1/4" from
the front of the cutout.
NOTE: Mounting screws must be
used. Failure to do so could result in
the oven falling out of the cabinet
causing serious injury.
_3-] Secure the oven to cabinet with screws
provided.
Note: Before drilling the pilot holes
make sure the oven is pushed as far
back into the opening as it will go
and centered.
10