Adjusting Oven Height - Kenmore 79030522802 Installation Instructions Manual

GAS WALL OVEN INSTALLATION INSTRUCTIONS
4. Adjusting Oven Height
(Model with 1 2 oven cavity only)
Remove and lay aside the lower vent decorative
trim that is taped to the side or to the top of the
oven. The decorative trim will be fastened to the
lower front of the oven after it has been installed in
the cabinet.
There is a 1 Y2" height adjustment on models with
extension panel (see figure 4). With this adjustment
and a 2" trim overhang, a unit can be installed in
existing openings 37 2" to 39" high.
Adjustment
Holes
Extension
Panel Mounting
VA Screws
py
Figure 4
To adjust oven height:
1. Lay oven on its back (see figure 5).
2. Remove the 6 screws that fasten the side
extension panel to the bottom sides of the oven.
3. Move each panel down to the position
that increases the oven height to fit your
opening. Each position changes oven height
approximately 1/2".
4, Line up the appropriate holes in the side
extension panels and sides of the oven. Put the 6
screws back.
5. Proceed with oven installation. Return to upright
position.
Oven Door
Figure 5
5. Cabinet Installation
Insert appliance into cutout. Use the 4 mounting
screws provided to fasten the front frame of the
appliance to the cabinet (steps 1 below). Keep the
2 decorative screws to fix the decorative trim to
the cabinet (step 2 below). The mounting holes in
the front frame of appliance may be used as a
template to locate the appliance mounting screw
holes on the cabinet.
To fasten the appliance to the cabinet (figure 6):
]. Use 4 mounting screws supplied to secure the
appliance to the cabinetry. 2 holes are located
under the center vent trim on each side, the
2 other holes are visible when the drawer is
opened.
2. Optional: Install the decorative trim under the
appliance (as shown on figure 6) using the 2
decorative screws supplied with the appliance.
Center Vent Trim
Mounting Screws
Figure 6