Clarion VRX928RVD Owner's Manual page 55

Setting the Auto Panel
When you turn on or off the power, you can set
the liquid crystal panel automatically housing or
opening.
The factory default setting is "OFF".
1. Press the [ADJ] button to select the ADJUST
MODE menu.
2. Touch the [ ] key to select "AUTO PANEL".
Touch the [AUTO PANEL] key.
3. Touch the [ON], [OFF] or [CLOSE] key to set it.
ON: The liquid crystal panel houses
automatically after turning off the
power, removing the DCP.
And the liquid crystal panel open
automatically after turning on the
power, attaching the DCP.
OFF: Normal operation.
CLOSE: The liquid crystal panel houses
automatically after turning off the
power, removing the DCP.
4. Press the [ADJ] button again or touch the
[RTN] key to return to the previous mode.
Cellular phone interrupt setting
If you connect this unit and your cellular phone
with a separately sold cable, you can listen to
your telephone calls on your car speakers.
The factory default setting is "OFF".
1. Press the [ADJ] button to select the ADJUST
MODE menu.
2. Touch the [TEL] key to select "TEL SWITCH".
Touch the [TEL SWITCH] key to select "ON",
"OFF" and "MUTE".
OFF:
This unit continues normal operation even
when the cellular phone is used.
Note:
• When the setting is OFF, disconnect the cellular
phone from the cable or turn off the power of the
cellular phone.
ON:
You can listen to your telephone calls from
the speakers connected to this unit.
When listening to your calls on your car
speakers, you can adjust the volume by
operating the [VOL] button.
MUTE:
The sound from this unit is muted during
telephone calls.
3. Touch the [ON], [OFF] or [MUTE] key to
select a desired mode and set it.
4. Press the [ADJ] button again or touch the
[RTN] key to return to the previous mode.
This function is not compatible with all cellular
telepones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
Setting the car speaker output for
the cellular phone
The factory default setting is "RIGHT".
To output the telephone calls, set the cellular
phone interrupt to ON.
1. Press the [ADJ] button to select the ADJUST
MODE menu.
2. Touch the [TEL] key to select "TEL SP".
Touch the [TEL SP] key to select "LEFT" and
"RIGHT".
LEFT:
Telephone calls can be heard on the left
speaker connected to this unit.
RIGHT:
Telephone calls can be heard on the right
speaker connected to this unit.
3. Touch the [LEFT] or [RIGHT] key to select a
desired mode and set it.
4. Press the [ADJ] button again or touch the
[RTN] key to return to the previous mode.
Note:
• During cellular phone interrupt, speakers setting
is impossible.
Other Functions
63
VRX928RVD