Adjusting The Volume - Clarion VRX928RVD Owner's Manual

10. OPERATIONS
Basic Operations
CAUTION
When the unit is turned on, starting and stopping
the engine with its volume raised to the maximum
level may harm your hearings. Be careful about

adjusting the volume.

Note:
• Use this unit after starting the engine.
Turning on and off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car's
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [FUNC] button.
2. The illumination and display on the unit light
up. The unit automatically remembers its last
operation mode and will automatically switch
to display that mode.
3. Press and hold the [FUNC] button for 1 sec-
ond or longer to turn off the power for the
unit.
Note:
• About the "SYSTEM CHECK"
The confirmation of connected equipment must
be performed for this unit only when the wiring
connection is complete and power is turned on to
the unit first. When the power is supplied, "PUSH
PWR" appear in the display. Press the [FUNC]
button, the system check starts inside the unit.
When "COMPLETE" and "PUSH PWR" appear al-
ternately, press once again the [FUNC] button.
Selecting a mode
1. Press the [FUNC] button to change the mode
of operation.
2. Each time you press the [FUNC] button, the
mode of operation changes in the following
order:
Radio mode DAB mode
CD changer mode
DVD changer mode
mode Radio mode...
External equipment not connected with
CeNET is not selected.
22
VRX928RVD
Note: Be sure to read this chapter referring to the front diagrams of
chapter "2. CONTROLS" on page 5 (unfold).
ACC or engine
ON position
DVD mode
MD changer mode
TV mode VISUAL
Adjusting the volume
1. Operate the [VOL] button in the direction of
the + (up) or – (down) to adjust the volume;
+ : Increases the volume.
– : Decreases the volume.
The volume level indicated in the display is in a
range from 0 (minimum) to 33 (maximum).
CAUTION
While driving, keep the volume at a level at which
external sounds can be heard.
Switching the display
When the panel is closed:
1. Press the [DISP] button to select the desired
display.
Each time you press the [DISP] button, the
display switches in the following order:
In Radio mode
(RDS: PS name
DAB: Ensemble name)
MAIN Display
F1
SUB Display
Clock Time (CT)
CT
Display
Notes:
• Once selected, the preferred display becomes the
default display. When a function adjustment such
as volume is made, the display momentarily
switches to that function's display, then returns
back to the preferred display several seconds af-
ter the adjustment.
• If a title has been input, it is shown in the SUB
display. If no title has been input, "NO TITLE" ap-
pears in the display. To input a title, refer to the
subsection "Entering titles" in "Other Functions"
section.
• For CD, MD and TV, some special characters of
the title will not be displayed on the Information
Panel of the DCP. In this case, those characters
will only be left blank.
• When CT data is not received, "CT—:—" appears
in the display.
BBC R1
98.10
NEWS
10:56