Casio CTK-6300in User Manual page 91

Using the Song Sequencer
To adjust the velocity value of a note event
1.
Display the event editor screen of the track you
want to edit.
• See "To select a track for editing" (page E-83).
2.
Depending on the type of adjustment you want
make, perform one of the operations below.
To adjust this:
Individual note event
All note events in a track
Note events within a
specific range in a track
3.
While holding down the R-13 (FUNCTION)
button, press the C-13 (MENU) button to display
the event editor menu.
4.
Use the R-17 (t, y) button to move the 0 to
"VelocityMod." and then press the R-16
(ENTER) button.
• This displays the "Velocity Modify" screen.
5.
Use the dial or R-14 (–, +) buttons to change the
mode indicated in the thick brackets (%).
To adjust this:
Individual note event
All note events in a track
Note events within a specific range
in a track
• While the "Locator" mode is selected, use the R-17 (u,
i) buttons, the dial, or the R-14 (–, +) buttons to
specify the range whose note event velocity value you
want to adjust.
E-90
Do this:
On the event editor screen,
move the cursor to the note
event you want to adjust and
then advance to step 3.
Advance to step 3.
Advance to step 3.
Select this mode:
Cursor
All
Locator
6.
Press the R-16 (ENTER) button.
• This will display the setting screen like the one shown
below.
• The following explains the meanings and setting ranges
of the on-screen items. The settings marked with an
asterisk (*) in the "Setting Range" column are initial
defaults.
Item name Description
Fix Specifies a fixed value as the
(Fixed value) velocity value.
Select "oFF" for this setting
to adjust based on the
current velocity value of each
note event.
Rate These settings are enabled
(Velocity Rate) only when the "oFF" is
selected for the "Fix" setting.
They change the velocity
value of each note event
according to the
mathematical expression
(decimal parts cut off) shown
Offset
below. 1 is used when the
(Velocity Offset)
value produced by the
expression is less than 1,
and 127 is used when it is
greater than 127.
(Current velocity) X (Rate
setting) + (Offset setting)
7.
To change the setting to the desired value,
press the R-16 (ENTER) button.
8.
In response to the "Sure?" message that
appears, press the R-14 (YES) button to execute
the adjustment or the R-14 (NO) button to
cancel.
Setting Range
*
oFF , 001 to 127
*
000% to 100% to
200%
*
–126 to 000 to
+126