Part Parameters - Casio CTK-6300in User Manual

Using the Mixer

Part Parameters

Part parameters include setting items that can be adjusted for parts A01 through A16 and B01 through B16.
Parameter Name
TONE Specifies a tone for each part. When configuring this parameter, you can use the
(Part Tone) buttons from R-1 ([A] PIANO) through R-12 ([L] USER TONES) to select a tone
group.
Part Specifies if the notes of a particular part should be output (on) or not output (oFF).
(Part On/Off) When a part is turned on, the part number is displayed along the bottom of the level
meter. Part numbers are not displayed for parts that are turned off.
When playing back a MIDI file or song sequencer song, a "Sol" (Solo) option can be
specified to play a specific part only. To switch to "Sol", press both R-14 (–, +)
buttons at the same time.
Volume Specifies the volume level of each part.
(Part Volume)
Pan Specifies the stereo pan position of each part. 0 indicates the center, while a smaller
(Part Pan) values shifts to the left and a larger value shifts to the right.
CoarseTune Specifies, in semitone steps, the pitch of the notes of each part.
(Part Coarse Tune)
FineTune Specifies, in cent steps, the pitch of the notes of each part.
(Part Fine Tune)
BendRange Specifies the bend range of each part.
(Part Bend Range)
DSP Line Specifies whether DSP should be applied to each part. Changing this setting from
(Part DSP Line) "oFF" to "on" automatically switches the "Chorus/DSP" setting (page E-41) to "DSP".
Rev.Send Specifies how much reverb is applied to each part.
(Part Reverb Send) No reverb is applied at all when this setting is 0, while maximum reverb is applied
when it is 127.
Cho.Send Specifies how much chorus is applied to each part.
(Part Chorus Send) No chorus is applied at all when this setting is 0, while maximum chorus is applied
when it is 127.
Scale Specifies whether scale (page E-21) settings should be applied (on) or should not be
(Part Scale Enable) applied (oFF). Equal temperament is applied to parts when this setting is "oFF".
E-42
Description Setting Range
A:001 to L:010
*
oFF, on
*
0 to 127
*
–64 to 0 to +63
*
–24 to 0 to +24
*
–99 to 0 to +99
*
0 to 2 to 24
*
oFF , on
*
0 to 40 to 127
*
0 to 127
*
oFF, on