Lamp Information; Setup And Cleaning - Loewe Articos 55 HD Operating Instructions Manual

Setup

Lamp information

Articos 55 HD is equipped with a special
Longlife lamp to provide you with many hours
of service free performance. Rated at 120
Watts, it is responsible for the stunning picture
contrast.
Lamp burn out
Do not block the ventilation opening of the rear
cooling fans. Disturbances in the air stream will
cause the lamp to overheat and burn out. Keep
all ventilation openings clear of objects.
Do not switch the TV on/off in short intervals.
Frequent switching may decrease the life of the
projector lamp. Allow the lamp to reach its full
operating temperature before switching the TV
off. Allow the lamp to cool down before
switching the TV on again.
The lamp is electronically protected and will
not restart in critically hot condition. The TV will
remain in stand-by until the lamp has cooled
off.
Ventilation maintenance
During TV operation the projector lamp and
light engine are cooled by two fans located on
the TV rear panel.
The filters in front of these fans will collect dust
and may need to be cleaned from time to time.
The cleaning interval depends on the set up
position of the television.
Use a vacuum cleaner to clean the filters. Set it
on low power and gently guide it along the
ventilation grille.
In normal use, the filters should be checked at
least every six months.
31599_021_Articos55_GB_(ro)
Changing the lamp
Do not change the projector lamp yourself.
Interventions inside of the unit will void the
guarantee unless done by the dealer. Have your
dealer replace the defective lamp.
Note:
The built-in long-life lamp is a wearable part
which is excluded from the guarantee.
Please consult your dealer to have a defective
lamp replaced.
7

Setup and cleaning

• Set up the TV set with sufficient space for
ventilation. The openings for ventilation
must not be covered with objects, such as
magazines, tableclothes, curtains etc.
100 mm 100 mm
100 mm
.
• Do not place any sources of fire, such as
burning candles etc on the unit.
• Make sure that the screen is not exposed to
bright light or sunlight, otherwise it creates
reflections and the brilliance of the screen is
lost.
•
When choosing the location, please bear in
mind that the set weighs 76.5 kilograms. If
you stand the set on furniture (e.g. a table
or sideboard), check their load capacity first.
•
Take the swing range into account when
installing a set with a motorized rotary
stand.
Clean the glass plate of the screen with a soft
moist piece of cloth.
Also clean the other components of the system,
such as the remote control, only using a soft
moist piece of cloth (without any strong or
scouring agents).
24.03.2004, 13:28 Uhr
100 mm
7