Loewe Articos 55 HD Operating Instructions Manual page 24

Operating additional equipment
Operating other Loewe equipment with
the RC2 remote control
You can operate various Loewe equipment with
this remote control. In the ex-factory state
Loewe equipment is set for TV, VCD, DVD, DVD-
Preceiver 8116DT (DVD/Audio), Certos (DEV1,
DEV2) which you can operate directly. The d-
box common in Germany is set for the Set Top
Box (STB).
Press the MOD button with
MOD
the display on.
– Mode –
TV
The Mode menu is displayed.
STB
DVD
VCR
Mark the equipment or the
equipment combination you
want to operate with the
rocker.
– Mode –
DVD
VCR
TV+DVD
TV+VCR
Press the SET button to accept
SET
the setting.
In addition you can operate equipment
combinations, e.g. this TV and a DVD player or
VCR. The bottom six buttons then take over
drive functions for the DVD player or VCR. In
this case, you cannot operate the Digital
Recorder.
24
31599_021_Articos55_GB_(ro)
Switching over the remote control for
operating equipment of other
manufacturers
You can switch over the remote control for VCRs,
DVD players and Set Top Boxes if the infrared
code of the equipment type is listed in the code
list or is in the code memory of the RC2.
Switching over is done on the one hand by
entering a four-digit code and on the other hand
the remote control suggests codes which you
can test on the switched on equipment.
If you cannot find the equipment in the code list,
try to switch over the remote control with "Step
by set".
Switching over the remote control - with
code input
Look for the code number of your equipment in
the code list. The list is sorted according to
equipment type - DVD, VCR, STB - and
alphabetically according to manufacturer. You
will find one or more code numbers next to the
manufacturer name.
MOD
– Mode –
>RC Setup<
TV
STB
DVD
SET
– RC Setup –
STB
DEV1
DEV2
HMM
SET
24
Press the MOD button with the
display on. The Mode menu is
displayed.
Mark >RC Setup< with the
rocker.
Press the SET button to call the
RC settings.
Mark the equipment type with
the rocker - VCR, DVD, STB,
DEV1 (device 1), DEV2 (device
2).
Call the Setup menu with the
SET button.
24.03.2004, 13:28 Uhr
Mark "By code" with the
rocker.
Setup DEV2
By code
Step and set
back
Press the SET button to show
SET
the Setup menu.
Enter the four-digit code from
Setup DVD
Code ?
the code list with the number
buttons.
* * * *
First enter the type of
equipment for DEV1 and DEV2:
1 = DVD (DVD player)
Setup DEV2
2 = VCR (video recorder)
Type/Code ?
3 = STB (Set Top Box)
* * * * *
4 = Certos
then the four-digit code from
the code list.
When the first digit is
Setup DVD
underscored again, check
Code ?
whether your input was
1 2 3 4
correct. You can correct it by
re-entering.
Confirm the input with SET if it
SET
is correct.
Exit the SETUP menu with
MOD
MOD.
– Mode –
You will see the Mode menu
>RC Setup<
TV
with the equipment selection
STB
DVD
again.
Select the device you have just programmed to
test the functionality. If the device cannot be
operated or is difficult to operate, repeat the
code input with the next code from the list. If
no other codes are specified, try a code
suggested by the remote control.