Table of Contents
Advertisement
Installation
Instructions
STEP 17 DISHWASHER WET TEST
[] Turn on power supply
(or
plug power cord into outlet,
if equipped),
[] Latch door.
[] Push "Rinse Only" button.
[] Push start/reset pad once. Dishwasher should start.
[] Check to be sure that water enters the dishwasher. If water
does not enter the dishwasher, check to be sure that water
and power is turned on.
[] Check for leaks under the dishwasheE If leak is found, turn
power supply off, then tighten connections. Restore power
after leak is corrected.
[] Check for leaks around the door. A leak around the door
could be caused bg door rubbing or hitting against adjacent
cabinets. Reposition the dishwasher if necessary. See
Step 12.
[] The dishwasher will drain and turn off about 5 minutes after
it was started. Check drain lines. If leaks are found, turn
power suppl Uoff and correct leaks as necessar U.Restore
power after corrections are made. See Step 5A and 14.
[] Open dishwasher door and make sure most of the water has
drained. If not, check that disposer plug has been removed
and/or air gap is not plugged. See Step 14.
[] Press Start/Reset pad once again and run dishwasher
through another "Rinse Only" cycle. Check for leaks and
correct if required.
STEP 18 REPLACE TOEKICK
, Place toekick against the legs of the dishwasher.
Attachment_
Figure
BB
o Align the toekick with the bottom edge and make sure it is
against the floor.
Insert and tighten the two toekick attachment screws. The
toekick should stag in contact with the flooE
TIP: Make sure toekick is against floor to minimize
noise.
STEP 19 LITERATURE
, Be sure to leave complete literature package and
Installation Instructions with the consumer.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
GE Consumer
& Industrial
General Electric Company
Louisville, Kentuck U 40225
ge.com
O 2005
General
Electric
Company
Pub. No. 31-30590-1
Dwg. No. 206C1559P132
ND 05L-1496
(12/05)
Revised
12/05
Advertisement
Table of Contents
