Table of Contents
Advertisement
INSTALLATION
REQUIREMENTS
Yourair conditioner will install intostandard double hung
windows with actual clear opening widths of 27 to 39 inches
(6B6mm to 990mrn) (FIG, 1).
Lower sash must open sufficiently to allow a clear
vertical opening of 16 inches (406mm). Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser
for heat removal. The rear of the unit
must be outdoors,
not inside a building or garage.
s0sh
. 27" to 39"
/ N:
:: t:; _ei_
oWflf_de_
TM
Interior wall "._.
1."
FIG. 1
ELECTRICAL
SERVICE
Check your available electrical service. The power
supply available must be the same as that shown
on the unit nameplate (found on right side of cabinet).
All models are equipped with a 3-prong service plug
to provide proper service and safe positive
grounding.
Do not change plug in any way. Do not
use an adapter plug. If your present wall outlet does
not match your plug. call a qualified electrician to
make the necessary corrections.
SAVE CARTON and this OWNER'S
MANUAL for
future reference.
The carton is the best way to store
unit during winter or when not in use.
To avoid risk of persbnal injury, property damage,
or product damage due to the weightof this
device and sharp edges that may be exposed:
Air conditionerscovered in this manualpose an
excessiveweight hazard. Two or more people
are needed to move and installthe unit.
To prevent injuryor strain, use properliftingand
carryingtechniqueswhen movingunit.
• Carefully inspectlocationwhere air conditioner
will be installed. Be sure itwill support the
weightof the unitover an extended periorof
time.
• Handle air conditionerwith care. Wear
protective gloves whenever lifting or carrying the
unit, AVOID the sharp metal fins of front and
rear coils,
• Make sure air conditioner does not fall during
installation,
INSTALLATION
HARDWARE
FIG. 2
ITEM
NAME OF PARTS
Q'TY
A
SIDE CURTAIN
2
B
SILL SUPPORT
2
C
BOLT
2
D
LOCK NUT
2
E
SCREW: 25/64"
13
F
SCREW: 5/6"
3
G
SCREW: 5/6"
5
H
FOAM SEAL
1
I
FOAM STRIP
1
J
L BRACKET
1
i REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwddver
• Pliers
• Sharp knife
• 3/8-inch open end wrench or adjustable
wrench
• 1/4-inch hex socket and ratcher
• Tape measure
Electric ddlt
1/4-inch drill bit
/
-5-
Advertisement
Table of Contents
