Surface Cooking - Kenmore 61021 Owner's Manual

Surface Cooking
Lighting Instructions for
Standing Pilot Models
The surface burners on these
ranges have standing pilots
that must be lit initially. To
light them:
1. Be sure the surface
burner control knobs are
in the OFF position.
2. Remove the grates and lift the cooktop up (see the
Lift-Up Cooktop section).
3. Locate the two pilot ports and light each of them
with a match.
NOTE: If the pilot is too high or low, you can adjust it_
See the Adjust the Surface Burner Pilots If Necessary
section of the Installation Instructions.
4. Lower the cooktop, Your surface burners are now
ready for use.
5. Observe the lighted burners. Compare the flames to
pictures in the Problem Solver, If any flame is
unsatisfactory, call for service.
Lighting instructions for
Electric Ignition Models
Your surface burners are lighted by electric ignition,
eliminating the need for standing pilot lights with
constantly burning flames,
In case of a power failure, you can light the surface
burners on your range with a match_ Hold a lighted
match to the burner, then turn the knob to the LITE
position. Use extreme caution when lighting burners
this way.
Surface burners in use when an electrical power failure
occurs will continue to operate normally_
The electrode of the spark igniter is exposed_ When
one burner is turned to LITE, allthe burners
spark. Do not attempt to disassemble or clean
around any burner while another burner is on. An
electric shock may result, which could cause you to
lmock over hot cookwareo