Advertisement
AssemblingThe Tank Guide and Grill Drawer
,
Attach the Pressure Cylinder
Holder and Tank
Guide to the Cart Legs-Wheel Side as shown
in Fig. 4a. Align the holes of both parts with
the tapped holes on Cart Legs-Wheel Side.
Secure firmly using 4 of the 1/4"x112" Phillips
head screws provided.
2.
Install a 1/4"x1/2" Phillips head screw to the
rear of each Drawer Track. Without these
screws the drawer will not stop propedy.
3.
Slide the Drawer into the Drawer Tracks until
it stops. See Fig. 4b.
4,
Install a 1/4"x112" Phillips head screw to the
front of each Drawer Track. This important
step prevents the drawer from being pulled
outside the tracks.
See Fig. 4b.
installing
The Grill Head
.
Now that you've assembled the grill cart you
can install the pre-assembled Gdll Head.
See Fig. 5. To reduce the weight of the Gdll
Head, we suggest you open the Gdll Lid and
remove the packed components.
Even with
the components
removed,
this step requires 2
people to lift and position the Gdll Head onto
the griU cart. Be sure to align the 2 holes
beneath the hang ledge on each side of the
Gdll Head with the 2 holes on each cross
brace of cart. Raise Gdll Lid and insert 4 of
the 1/4"xl-3/8"
Phillips head screws and lock
nuts and tighten securely.
2.
From the back side of grill head, install the
Grease Draining Tray. See Fig. 5.
3.
Center the Grease Receptacle under Grease
Draining Tray. See Fig. 5.
Figure 4a
DRAWER
TRACK
DRAWER
PRESSURE
CYLINDER
HOLDER
TANK GUIDE
Figure 4b
J
DRAWER
Figure 5
CROSS
BRACE
GREASE
RECEPTACLE
GRILL HEAD
i
/
//
GREASE
DRAINING
TRAY
HANG LEDGE
Advertisement
