Advertisement
AWARNING
A strong gas smell, or the hissing sound of
gas indicates
a serious
problem with your gas
gdll or the LP gas tank.
Failure to immedi-
ately follow the steps listed below could result
in a fire or explosion
that could cause sedous
bodily injury, death, or
property damage.
Shut off gas supply to the gas grill.
Turn the control knobs to OFF position.
Put out any flame with a fire extinguisher.
Open gdll lid.
Get away from the LP gas tank.
Do not try to fix the problem yourself.
If odor continues
or you have a fire you
cannot extinquish,
call your fire department.
Do not call near the LP gas tank because
your telephone
is an electrical
device and
could create a spark resulting
in fire and/or
explosion.
Checking
For LP Gas Leaks
Never test for leaks with a flame. Prior to first
use, at the beginning of each season, or every
time your LP gas tank is changed, you must
check for gas leaks. Follow these four steps:
1. Make a soap solution
by mixing one part
liquid detergent
and one part water.
2, Turn the grill control knobs to the full OFF
position, then turn the gas ON at source.
3. Apply the soap solution
to all gas connec-
tions. If bubbles appear in the soap solution
the connections
are not properly sealed.
Check each fitting
and tighten or repair as
necessary.
4. If you have a gas leak that you cannot
repair, turn off the gas at the source,
discon-
nect fuel line from your gdll and cell
1-800-4-MY-HOME
or your gas supplier for
repair assistance.
/ WARNING
Failure
to open the grill lid during the
lighting
procedures
could result in a fire
or explosion
that could cause serious
bodily
injury, death,
or property
damage.
6. Set control knobs to OFF and open the LP gas
tank valve slowly until 1/4 to 1/2 open.
7. Push and turn the LEFT control knob to HIGH.
8. Immediately
press the electric ignitor for 3-4
seconds to light the burner.
9. If the burner does not light, tum the control knob to
OFF, wait 5 minutes for gas to clear, then retry.
1g. Once the first grill burner is ignited, the adjacent
burner can be lit by simply turning its control knob
toHIGH.
11. Adjust control knobs to your desired cooking
temperature.
Lighting Your Grill by Match
To light your gas grill by match, follow steps I through
6 of the Basic Lighting Procedures. Then, insert a lit
match through the lighting hole on either side of the
grill. See Fig. 14. Turn the nearest control knob to the
HIGH setting to release gas. The burner should light
immediately.
Figure 14
_ETING
Basic Lighting Procedures
1. Familiarize yourself with the safety guidelines at
the front of this manual. Do not smoke while
lightinggrill or checking gas supply connectP
2. Be sure the LP gas tank is filled.
3. Check that the end of each burner tube is propedy
locatedover each valve orifice.
4. Make sure all gas connections are securely
tightened.
5. Open the gdll lid.
/ WARNING
Never lean over the grill cooking area while
lighting your gas grill. Keep your face and
body a safe distance
(at least 18 inches)
from the lighting hole or burners, when
lighting your gdll by match.
13
Advertisement
