Kenmore 580.75119 Owner's Manual page 11

PROCEDURE C
[H'.,_I]II[e] _1
lil
To achieve rearward slope for unit draining,
remove the backing from the 13" shim strips
and attach them as shown below in Fig. 22.
The higher portion of shim is to be placed in
front of the rib on the base of wall sleeve.
h,0h_ r-
l High
FIG. 21
FIG. 22
_J_ Remove the metal and it with
rear grille
replace
the plastic rear grille to improve unit energy
efficiency. The plastic grille reduces the
amount of hot air discharge that recirculates
through the unit.
• Air conditioners coveredin this manualposean
excessiveweighthazard.Twoor morepeopleare
neededto moveandinstallthe unit.
To preventinjuryor strain,useproperliftingand
carryingtechniques when movingunit.
° Whenhandling the air conditioner,be carefulto avoid
cutsfrom sharpmetalfins on front and rearcoils.
, Makesureair conditioner d oesnot fallduring
removal.
• If unitdoesnotoperateafter installation check,to be
surethe circuitinterrupterhasnotbeentripped.Refer
to the Troubleshooting g uidefor resetprocedure.
Plastic rear grille
Steel rear
_'_ Install the new unit into the wall sleeve
_1'_ Assemble trim as described in Step 6,
Procedure A.
FIG. 23
-11-