Download Print this page

Kenmore Sears 95629 Use And Care And Safety Manual page 8

Advertisement

W , NING
• ALL RANGES
CAN TIP
o _NJUlRY COULD
RESULT
INSTALL
ANTmoT[IF
DEVICE
PACKED
WUTH
RANGE:
o SEE [INSTRUC:TIiOiNI$
TOOLS NEEDED:
Phillips head screwdriver
1-3/8" open end or adjustable
wrench
Bracket attachesto floor or wall to hold either rightor left
rear leg leveler. If fastening to floor, be surethat screws
do not penetrate electrical wlrlng or plumblng.
If this
cannot be determined, use shorter screws that will not
penetrate through flooring.
if the bracket
came with your range, tt Is shipped at-
tached to the lower range back. Remove and discard
the shipping screw that holds the bracket and then
follow instructions below.
1. Decide whether the bracket will be Installed on the
right or left side of range location.
2. Ifthe bracket side ofthe range Isadjacent to acablnet,
place the bracket against back wall and cabinet as
shown In Figure 1.
if there Is no adjacent
cabinet, determine where the
!ocatlon
of the range side (painted outside panel) will
be. Place the bracket with Its outside edge at this
location and against back wall. See Flgure I.
3. Determ ine whether you will anchor the bracket to the
floor or wall. Fasten the bracket securely with the
screws provided.
Screws are self-drilling
In wood,
plywood, particle and chip board, and most metal
framlng.
If attaching to masonry you can buy suitable
screws
and anchors
at hardware
stores.
Use a
masonry
drill to drill the required holes.
4. Using the wrench, back out the four leg levelers at
least two turns. See your Installation guide for more
leveling Information before positioning
range.
5. Slide the range Into place. Be sure rear leg leveler
fully engages
slot in bracket.
If range cannot be
moved back far enough for rear leg leveler to enter
bracket, move bracket forward as required and attach
to floor In new location.
ADJACENT CABINET OR FINAL
LOCATION OF RANGE SIDE
PANEL
OUTSIDE EDGE OF
BRACKET TO BE
FLUSH WITH LEFT OR
RIGHT SIDE OF RANGE
\
WALL BEHIND
RANGE
Fig. 1
BRACKET
scREW MUST ENTER
WOOD OR METAL
WALL
PLATE
/
°-><1
Fig. 2
ATTACHMENT TO WALL
7
NCINS01

Advertisement

loading

This manual is also suitable for:

95629