Midi In And Midi Out Ports; Headphones Jack; Speaker Simulated Line Out Jacks - Fender Cyber-Deluxe DSP 7 Operating Instructions Manual

Rear Panel Overview
14
w w w w w w . . f f e e n n d d e
KK. MIDI IN PORT
Standard MIDI connection used to receive data from an external MIDI
device (see MIDI Capabilities on page 27).
LL. MIDI OUT PORT
Standard MIDI connection used to transmit data to an external MIDI device
(see MIDI Capabilities on page 27).
MM. HEADPHONES JACK
Connection for headphones using a standard 1/4˝ stereo phone plug. Use
of this jack automatically mutes the Cyber–Deluxe™ amplifier speaker and
EXPANDER jack {QQ}. This stereo output incorporates speaker simulation
circuitry to produce sound similar to that of miked guitar amp speakers
(compensating for the frequency response of headphones).
Cable Type and Signal Quality
NOTE: Jacks NN, QQ, SS and TT are all impedance balanced TRS
(Tip–Ring–Sleeve) connections, with (+) on tip and (-) on ring.
standard TS (Tip–Sleeve) mono guitar cords with these jacks is acceptable,
but the use of 3-conductor (stereo-type) TRS cords could significantly
improve sound quality (signal/noise ratio) in certain situations.
NN. LINE OUT JACKS
Line–level stereo output connections for use with sound reinforcement and
recording equipment. These outputs also incorporate speaker simulation
circuitry. For (summed) mono output, use only the L/MONO jack.
✧
e r r . . c c o o m m w w w w w w . . m m r r g g e e a a r r h h e e a a d d . . n
Using
n e e t t