Turning On Your System While You Are At Home; (Stay Mode); Turning On Your System With No Access Code (Quick Arm) - DSC Envoy NT9010 User Manual

Turning On Use the Stay mode when you want to stay on the premises, and also want to pre-
Your System vent unauthorized entry from outside. The system will only turn on the perimeter
zones (e.g. door and window contacts), and will leave the interior zones off (e.g.
While You Are
motion detectors) so that you will be free to move around inside.
At Home (Stay
Mode)
1. Check that your system is ready (green Ready light is ON)
2. Enter your [access code]. As you enter each digit, the keypad sounder beeps.
3. DO NOT leave through the entry/exit door. This tells the system that you are not
Re-activate bypassed zones
To turn on the rest of the system when it is in Stay mode:
1. Press
NOTE: When you have turned on the interior zones, you will not be able to
enter areas protected by motion detectors, or open doors and windows. To
access these areas, you must enter your [access code] and turn off the sys-
tem.
Stay Button
You may also be able to quickly Stay arm your system using the "Stay" function
button on your keypad. If your installer has programmed this button, press and
hold it for two seconds to turn your system on in Stay mode.
Your installer will tell you if the Quick Arm method is enabled on your system.
Turning On
Your System Using the following method, you can quickly turn on your system without having
With No to enter an access code.
Access Code
1. Check that the system is ready (green Ready light is ON)
(Quick Arm)
2. Press
3. Go out through the entry/exit door. The system will be in Away mode. If you do
12
If you entered the access code incorrectly, the keypad sounder will buzz steadily
for two seconds. Re-enter your access code correctly.
When you enter a valid access code:
• The keypad sounds fast beeps.
• The red (Armed) light turns ON.
• The exit time begins and the keypad beeps once every second. The keypad
will beep quickly for the last 10 seconds of the exit time.
leaving, and the system automatically turns off the interior zones.
At the end of the exit time, all keypad lights, except the red (Armed) and yellow
(System) lights, turn OFF. The system is now on.
. The interior zones are now on.
1
.
0
• The keypad sounds fast beeps.
• The red (Armed) light turns ON.
• The exit time begins and the keypad beeps once every second until the
end of the exit time.
not exit, the system will be in Stay mode.