Arming Options; About Home-Away Zones; At-Home Arming; Home-Away Arming - DSC PC51O Instruction Manual

ARMING OPTIONS

About Home-Away Zones

Some zones on your system may be programmed as Home-Away Zones so that you may use the Arming
Options described on this page. Home-Away Zones feature the ability to be automatically bypassed when the
commands described below are entered; this saves you the trouble of having to manually bypass zones using
∗
the [ ][1][Access Code] Bypass command.
Your installer will inform you of which zones on your system are programmed as Home-Away Zones.

At-Home Arming

At-Home Arming automatically bypasses the Home-Away Zones on your system, and removes the Entry
Delay from the Entry-Exit Zones. This feature allows you to arm the system and remain on the premises.
In addition, if any of the Entry-Exit doors are opened, an alarm will sound instantly.
To use At-Home Arming, enter [
remind you that there is no Entry Delay on the Entry-Exit doors.

Home-Away Arming

Home-Away arming automatically bypasses the Home-Away Zones; the Entry Delay will still apply to the
Entry-Exit zones. You may use this feature to arm the system and remain on the premises. Another
household member would still be able to enter the premises through the Entry-Exit door without causing
an alarm. When the Entry-Exit door is opened, an Access Code would have to be entered to disarm the
system.
To arm the system with Home-Away Arming, enter an Access Code and do not open the Entry-Exit door.
When the Exit Delay expires, the system will be armed with the Home-Away Zones automatically bypassed.

Quick-Arm

The Quick-Arm feature allows you to enter [
someone to arm the system without that person having to be provided with an Access Code. When [
is entered, the "Armed" light will come ON and the Exit Delay will begin; you may now leave the premises
through the Entry-Exit door. At the end of the Exit Delay, the system will be fully armed.
6
∗
][9][Access Code] on the keypad. The "Armed" light will FLASH to
∗
][0] to arm the system. This command is designed to allow
∗
][0]