End Of Forms (Eof) Test - Lexmark 7200 Color Jetprinter Service Manual

4092

End of Forms (EOF) Test

This test checks the EOF sensor on the system board.
During the test, the power light blinks rapidly. The Busy Light shows
the EOF sensor status in the following manner:
•
On - paper is in sensor
•
Off - paper is not in sensor
To run the test:
1. Turn the printer off and place a two pin jumper on connector J6
as shown below. (Pins 3 & 4).
2. To start the test, press and hold the Paper Feed button while
turning the printer on. Hold the button until the Power Light
blinks rapidly. Turn power off or unplug the printer to stop the
test.
3-4