User Manual for your Baumatic BHS320.5SS 30cm 2 Solid plate electric hob NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment.
No modifications to the appliance are permitted by Baumatic Ltd. o You should not store or place flammable or highly flammable liquids/materials on top of or near the appliance. Items made from...
Page 6
Child Safety o Baumatic strongly recommend that babies and young children are prevented from being near to the appliance and not allowed to touch the applianc e at any time. During and after use, all surfaces will become hot. o If it is necessary for younger family members to be in the kitchen,...
Page 7
Please specific section of this booklet that refers to installation. Baumatic Ltd. declines any re sponsibility for injury or damage, to person or property, as a result of improper use or installation of this applianc eclaration of conformity...
Specifications Product dimensions: Aperture dimensions: Depth: 510 mm Depth: 480 mm Width: 290 mm Width: 260 mm Height: 52 mm Product specifications: o 1 x 1.50 kW rapid plate (Ø 155 mm) o 1 x 1.50 kW standard plate (Ø 188 mm)
Hob surface layout A) 1.50 kW standard plate (Ø 188 m B) 1.50 kW rapid plate (Ø 15 5 mm) C) Power on indi cator light D) Control knob lectrical details Rated Voltage: 220-240 Vac, 50-60 Hz Supply Connection: 13A (double pole switched f used outlet wit h 3mm contact gap)
sing the hob Before first use IMPORTANT: You should clean the hob surface and solid plates (see “Cleaning and maintenance” section). o You should switch on one cooking zone at a time, for 5 minutes at the maximum setting. This will help to eliminate any new smell that exists and evaporate any h umidity that has formed on the heating elements during transit.
IMPORTANT: The hob surface is tough; however it is not unbreakable and can be damaged. Especially if pointed or hard objects are allowed to fall on it with some force. o DO NOT USE THE HOB IF THE SURFACE BECOMES BROKEN CRACKED. SHOULD CONTACT BAUMATIC CUSTOMER CARE DEPARTMENT IMMEDIATELY.
Cleaning and maintenance Cleaning and maintenance operations must only be carried out when the hob is cool. The appliance should be disconnected from your mains su pply before commencing any cleaning process. Cleaning the hob top Any residues that are left on the hob top surface from cleaning agents will damage it.
aintaining the solid plates o If something is spilt onto the plate itself, then it can be remo using a soft brush, plastic or nylon scourer and warm water. o To keep the solid plates in good condition, you should put a little olive oil onto a kitchen towel and rub it onto the surface of the plate.
When unpacking the appliance pleas e check that the following items re contained within the packaging: 1 Baumatic hob 1 Installation and i nstruction manual 1 Guarantee card 4 Fixing screws...
nstalling the appliance o Cut a hole in the worktop that corresponds with the drawing shown above. o IMPORTANT: You must observe the ventilation requirements show n in the drawing opposite. o IMPORTANT: Do not use a silicon sealant to seal the appliance against the aperture.
Page 16
o IMPORTANT: There ventilation holes around the outside of the hob. YOU MUST ensure that these holes are not blocked by the work top, when you put the hob into position (see drawing opposite). o Carefully turn the hob upside down and place it on a cushioned mat.
Electrical connection YOUR INTENDED FITTED PERMANENT INSTALLATION. o Cable type: H05 RRF 3 core x 1.5 mm² (Type RR-F <HAR> marked). o Before connecting the appliance, make sure that the supply voltage marked on the rating plate corresponds with your mains supply voltage.
The blue wire must be connected to the terminal marked “N” (neutral), or coloured black. The green and yellow wire must be connected to the terminal marked “E” (earth), or by the earth symbol, or coloured green and yellow. o When the connection is completed, no stray strands or cut wire should be present.
Page 19
Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
BC005 Stainless Steel Cleaner and Protector (250 ml) o BC007 E-Cloth – General Purpose Cloth o BC008 Microwave Cover To order a Baumatic consumable product please call 0123 5437 244 and quote the product code. You can also order online from eshop.baumatic.co.uk...