Installation Process Overview - Barco PFWX-51B User Manual

obstruction.

2.6 Installation process overview

Quick setup
The following steps describe briefly how to setup your PFWX-51B/PFWU-51B projector in a table mount front projection. Note
that each step refers to a corresponding procedure, which is more detailed and illustrated.
1. Install the batteries of the remote control. See
2. Place the projector on a solid table in front of the screen at the expected throw distance. Adjust the feet to ensure that
the projector is installed at right angles (horizontally and vertically) with the screen. See
mounted projector
3. Connect the projector with the local power net. See
4. Select and install an appropriate lens, which covers the throw ratio ( = screen size / projector screen distance).
See page 9: Positioning the
5. Switch ON the projector. See
6. Connect your source to the appropriate input module. See
7. Zoom and shift the lens until the image is properly projected on the screen, Do this by using the "ZOOM" and "FOCUS"
ring on the lens. If necessary, level the projector from side to side by turning the adjustable feet in or out. See
Lens zoom. or adjust the Lens Shift manually. See
PFWX-51B/PFWU-51B 07/08/2013
Ventilation outlet
page 12: Remote control unit
and page 36: Adjusting the lens by horizontal and vertical lens
projector.
page 18: Connecting the projector with the power
(RCU).
page 18: Connecting the projector with the power
page 23: Input and Communication.
page 36: Adjusting the lens by horizontal and vertical lens shift
Ventilation inlet
page 19: Alignment of a table
shift.
net.
net.
2.General
page 16:
11