Installation Process Overview - Barco SP2K-S Installation Manual

Installation process

3.1 Installation process overview

Installation process projector
1. Check if all installation requirements are fulfilled such as the environment conditions of the installation
area, electrical facilities, etc. Note that a solid pedestal is required to support the projector. For more info
see "Installation requirements", page
2. Physical installation of the projector upon its pedestal. For more info of the physical installation, see
"Physical installation projector", page
3. Optional installation of air exhaust adapter on the projector. For more info air exhaust adapter
installation, see "Installing air exhaust adapter (Optional)", page
4. Installation of the lens. First select a lens with appropriate throw ratio covering the screen size and the
projector - screen distance. Then install the lens in the lens holder of the projector. For more information
about available lenses, lens selection and lens installation see
Caution:
cover prior to installing the lens.
5. Installation of the HDDs. In case the HDDs of the ICMP are delivered separated from the projector
remove the protection tape from the HDD input slots and install all three HDDs as described in the
procedure"Installing a HDD into the ICMP-X", page
have the same storage capacity. See label on top of the HDD to know the storage capacity.
Note: Only required in case of projector variant with ICMP-X.
6. Electrical connection with the power net. See
7. Plug in the power connector and let the projector system start up automatically.
Note: If the projector does not start automatically, press the power button. For more information,
see "Projector Power Cycle", page
8. Connect your device to the projector for the first time and log into Web Communicator. See
"Connecting to the projector for the first time", page
9. Upgrade the projector software to the latest available version. See
10. Select the corresponding lens file for the installed lens and calibrate the lens. For more details, refer
to the user guide.
11. Alignment of the projected image on the screen. The image can be aligned with the screen size of the
application. Turn on the light source, activate the dowser and use the ZOOM, SHIFT and FOCUS buttons
to match the projected image with the screen. Tilt the projector in case you can not SHIFT the image
completely upon the screen. See
12. Adjust the light path. Normally the lens holder and the convergence of the projector are perfectly
adjusted at the factory. Nevertheless, some applications require a readjustment of the lens holder,
convergence or both. See procedure
13. Perform the projector configuration and adjustment to finish the installation process for the end user.
Please refer to the user guide for the configuration and adjustment process and details.
14. Projection of a digital cinema movie.
In case the projector is equipped with an ICMP-X, download the ICMP-X device certificate, request KDM
and DCP from your content supplier, ingest KDM and DCP, and play out the movie. for detailed
instructions see chapter
This topic only covers a basic configuration and adjustment process for the projector. For a more in-
depth explanation of the Web Communicator and all of its features, please refer to the projector user
guide.
If you have a projector with ICMP-X and you want a more in-depth explanation on how to control this
media player, please refer to the Web Commander user guide.
38 R5913197 /02 SP2K-S
24.
39.
The projector is delivered with a plastic cover inside the Lens Holder. Remove the
"Lens shift, zoom & focus", page
"Scheimpflug adjustment", page
"ICMP-X", page 71, and projector user guide.
49.
"Lenses & Lens holder", page
90. Make sure that all HDDs in the ICMP-X HDD set
"Connecting the projector with the power net", page
93.
102.
"Software update", page
58.
61, and
53.
44.
103.
"Convergence", page 107.