Tool Examples; Figure 172 Restore Using Ftp Session Example - ZyXEL Communications P-660HN FxZ Series User Manual

21.1.4 Tool Examples

Using FTP or TFTP to Restore Configuration
This example shows you how to restore a previously saved configuration. Note that this
function erases the current configuration before restoring a previous back up configuration;
please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device
since FTP is faster. Please note that you must wait for the system to automatically restart after
the file transfer is complete.
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device. When the Restore Configuration process is complete,
the device automatically restarts.
Restore Using FTP Session Example

Figure 172 Restore Using FTP Session Example

ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Refer to Section 21.1.2 on page 287
over WAN.
FTP and TFTP Firmware and Configuration File Uploads
These examples show you how to upload firmware and configuration files.
Do not interrupt the file transfer process as this may PERMANENTLY
DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use this feature,
your computer must have an FTP client. The following sections give examples of how to
upload the firmware and the configuration files.
FTP File Upload Command from the DOS Prompt Example
1 Launch the FTP client on your computer.
P-660HN-FxZ Series User's Guide
to read about configurations that disallow TFTP and FTP
Chapter 21 Tools
289