If the client device's configuration interface has an area for entering another
device's PIN, you can either enter the client's PIN in the AP, or enter the AP's
PIN in the client - it does not matter which.
5 Start WPS on both devices within two minutes.
Use the configuration utility to activate WPS, not the push-button on the device
itself.
6 On a computer connected to the wireless client, try to connect to the Internet. If you can
connect, WPS was successful.
If you cannot connect, check the list of associated wireless clients in the AP's
configuration utility. If you see the wireless client in the list, WPS was successful.
The following figure shows a WPS-enabled wireless client (installed in a notebook computer)
connecting to the WPS-enabled AP via the PIN method.
P-660HN-FxZ Series User's Guide
Chapter 7 Wireless LAN
131