Fax; Technical Reference; Sip Call Progression With Session Timer - ZyXEL Communications MAX208M User Manual

Wimax cpe series
Hide thumbs Also See for MAX208M:
Table of Contents

Advertisement

The following table describes the labels in this screen.
Table 74 Dialing
LABEL
Inter-digit
Timeout
First-digit
Timeout

10.7 FAX

Click VoIP > Account 1 (or Account 2) > FAX to configure which standard the account uses for
fax services.
Figure 97 FAX
The following table describes the labels in this screen.
Table 75 FAX
LABEL
Options

10.8 Technical Reference

The following section contains additional technical information about the WiMAX Device features
described in this chapter.

10.8.1 SIP Call Progression with Session Timer

The following figure displays the basic steps in the setup and tear down of a SIP call with session
timer supported by both peers. The UPDATE method is used to refresh the session. A calls B and
WiMAX Device Configuration User's Guide
DESCRIPTION
Set the time in seconds (1~5) the WiMAX Device waits for each digit input of a
complete callee number after you press the first key on the phone.
If the WiMAX Device cannot receive the next digit entered within this time
period, the WiMAX Device processes digits you have dialed.
Set the number of seconds (5~30) for the WiMAX Device to wait for you to
start dialing a number after you pick up the telephone receiver. If you do not
dial any number within that time period, the dial tone becomes a busy signal.
Put back the receiver and pick it up again if you want to make a new call.
DESCRIPTION
Select which standard the WiMAX Device uses to handle faxes. The peer devices must
also use standard.
G.711A Pass Through - Select this option to send and receive fax messages over the
network or Internet using VoIP (G.711a). By encoding fax data as audio data, faxes
may be susceptible to packet loss and other errors. However, as this standard is
considerably older than T.38, it is more compatible with older obsolete systems.
T.38 FAX Relay - WiMAX Device encodes fax messages to T.38 packets and sends as
UDP packets through IP networks. This provides better quality, but it may have
interoperability problems.
Chapter 10 The VoIP Account Screens
167

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents