Fax/Modem Enabler - ZyXEL Communications Comet 336P User Manual

Card Type : " Modem" (COM 2)
Manufacturer : " Intelligent"
Product Name : " AT&T FAX/MODEM"
[Configuration Information]
Configuring client handle is 9F20
Memory + I/O interface, Vcc 50, Vpp1 50, Vpp2 50
Config base 0100, Config values:
Option value : 61
Status value : 08
I/O rang 2F8-2FF, 8-bit
Assigned IRQ is 3 (enabled)
SLOT 1 :
SLOT 1 is empty
5. Run an application program, such as Telix or Procom Plus, and set the appropriate
COM port and IRQ settings.
6. Connect the FAX/MODEM interface cable and hook the RJ-11 plug to the
telephone line outlet.
7. Now you can make fax or modem connections with the application program.
ONote: Insert FAX/MODEM before running communication program.

Fax/Modem Enabler

MDMEN.EXE is the DOS enabler for the PCMCIA Fax/Modem. For systems without
any Card Services, you can use the enabler in the bundled INF file disk to enable the
Fax/Modem.
The enabler can be installed as a DOS command to be run from the DOS prompt when
you wish to use it, or you can put the enabler into the AUTOEXEC.BAT or
CONFIG.SYS files to load the driver every time you start your computer.
MDMEN [COM=m] [IRQ=nn] [SLT=n]
COM=m Specify the COM port value (m=1 - 3). Default is 2.
IRQ=nn Specify the interrupt request number in decimal. Default: 4 for COM1 and
COM3, 3 for COM2 and COM4.
SLT=n Specify the slot number the Fax/Modem card. Default: auto-detection.
Example: MODEMEN COM=2 IRQ=5 SLT=1
Technical Notes for Enabler
Installation 5