Table of Contents
Advertisement
– The power cord is damaged or frayed.
– A wall panel circuit breaker, fuse, or other safety device has
been tripped.
– Liquid is spilled into the copier/printer.
– The equipment is exposed to water.
– Any part of the equipment is damaged.
Disconnect Device
The power cable is the disconnect device for this equipment. It is
attached to the back of the machine as a plug-in device. To remove
all electrical power from the equipment, disconnect the power cable
from the electrical outlet.
Operational Safety Information
To ensure the continued safe operation of your Xerox equipment,
follow these safety guidelines at all times.
Do These:
•
Always connect equipment to a correctly grounded power outlet.
If in doubt, have the outlet checked by a qualified electrician.
•
This equipment must be connected to a protective earth circuit.
This equipment is supplied with a plug that has a protective
earth pin. This plug will fit only into an earthed electrical outlet.
This is a safety feature. To avoid risk of electric shock, contact
your electrician to replace the electrical outlet if you are unable
to insert the plug into it. Never use a plug that lacks an earth
connection terminal to connect the product to an electrical
outlet.
•
Always follow all warnings and instructions that are marked on
or supplied with the equipment.
•
Always exercise care when moving or relocating equipment.
Please contact your local Xerox Service Department, or your
local support organization to arrange relocation of the product to
a location outside of your building.
•
Always locate the equipment in an area that has adequate
ventilation, and the room for servicing. See install guide for
minimum dimensions
•
Always use materials and supplies specifically designed for your
Xerox equipment. Use of unsuitable materials may result in poor
performance.
•
Always unplug this equipment from the electrical outlet before
cleaning.
Do Not Do These:
•
Never use a plug that lacks an earth connection terminal to
connect the product to an electrical outlet.
•
Never attempt any maintenance function that is not specifically
described in this documentation.
•
This equipment should not be placed in a built-in installation
unless proper ventilation is provided, please contact your
Authorized local dealer for further information.
•
Never remove covers or guards that are fastened with screws.
There are no operator serviceable areas within these covers.
•
Never locate the equipment near a radiator or any other heat
source.
•
Never push objects of any kind into the ventilation openings.
•
Never override or "cheat" any of the electrical or mechanical
interlock devices.
•
Never operate the equipment if you notice unusual noises or
odors. Disconnect the power cord from the electrical outlet and
contact your local Xerox Service Representative or Service
Provider immediately.
Maintenance Information
Do not attempt any maintenance procedure that is not specifically
described in the documentation that is supplied with your copier/
printer.
•
Do not use aerosol cleaners. The use of cleaners that are not
approved may cause poor performance of the equipment, and
could create a dangerous condition.
•
Use supplies and cleaning materials only as directed in this
manual. Keep all of these materials out of the reach of children.
•
Do not remove covers or guards that are fastened with screws.
There are no parts behind these covers that you can maintain or
service.
•
Do not perform any maintenance procedures unless you have
been trained to do them by an authorized local dealer or unless
a procedure is specifically described in the user manuals.
Ozone Safety Information
This product will produce ozone during normal operation. The ozone
produced is heavier than air and is dependent on copy volume.
Providing the correct environmental parameters as specified in the
Xerox installation procedure will ensure that the concentration levels
meet safe limits.
ii
Advertisement
Chapters
Table of Contents
Troubleshooting
