Kenmore 580.75124 Owner's Manual page 7

D Select the position that will place the sill supports
near the outermost point on sill (FIG. 10). Attach the
sill supports to the cabinet track hole closest to the
selected position using screw (ITEM E).
[]Place the sill supports with the cabinet on the
window sill's selected position (FIG. 10).
ITEME
Cabinet
OUTDOOR
INDOOR FIG. 10
_l_The cabinet should be installed with a very slight
tilt (about 1/4") downward to the outside (FIG. 11).
Adjust the bolts and the nuts of sill supports to level
the cabinet.
ITEM B FIG. 11
_1 Attach the cabinet to the inner sill by driving the
screws (ITEM F) through the front lower guide into
the window inner sill. (FIG. 12)
Sash
......... Track
Lower Guide
ITEM B
FIG,
12
_"_ Pull each side curtain fully to each side of
window opening. Attach each side curtain to the
window sash using screws (ITEM G). (FIG. 13)
_J Attach the L bracket (ITEM J) with screw
(ITEM G) (FIG. 14).
ITEM G
ITEM J
FIG. 14
W DRAINAGE
Be sure to insert the drain pipe into base pan before
installation. The air conditioner must be installed
with a slight tilt downward to the outside for proper
water drainage (FIG. 15).
"_ BASEPANREAR
DRAIN_
/
BASEPANBOTTOM FIG. 15
_'_ Slide the air conditioner into the cabinet. (FIG. 16)
CAUTION: For security purposes, reinstall side screws
you removed in step 1.
Power
Cord
Screw
Screw
FIG. 16
_'_ Cut the foam seal (ITEM H) to the proper
length and insert between the upper window sash
and the lower window sash. (FIG. 17)
ITEM H
FIG. 17
_"_ The vent control handle must be straightened
. ITEM G 1_ ibef°re the decorative front is attached.
__]11 ! _ Pull down part @ to align with part (_.
....---L--"_Part @ _,:_!!, ii_j,J,_
FIG. 13 ', _,;,'i_"
-7 -
FIG. 18