Removing The Memory Module(S) - Dell XPS M1210 Service Manual

Back to Contents Page
Memory Module(s)
Dell™ XPS™ M1210 Service Manual
Removing the Memory Module(s)
Replacing the Memory Module(s)
Removing the Memory Module(s)
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see
computer.
NOTE: Memory modules purchased from Dell are covered under your computer warranty.
NOTE: Your computer has two memory module connectors: "DIMM B" is located at the bottom of the computer, and "DIMM A" is located underneath the
keyboard.
1. Follow the instructions in Before Working Inside Your
2. Remove the memory module in the connector labeled "DIMM B" which is located at the bottom of the computer:
a. Turn the computer upside down, loosen the captive screw on the memory module cover, and remove the cover.
NOTICE: To prevent damage to the memory module connector, do not use tools to spread the securing clips that secure the memory module.
NOTICE: Handle memory modules by their edges, and do not touch the components on a module.
b. Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
c. Remove the module from the connector at a 45-degree angle.
3. Remove the memory module from the connector labeled "DIMM A" which is located underneath the keyboard:
a. Turn the computer topside up, and remove the hinge cover (see
b. Remove the keyboard (see Keyboard).
Before Working Inside Your
Computer.
Removing the Hinge
Computer) before working inside the
Cover).