Display Panel; Removing The Display Panel - Dell XPS M1210 Service Manual

NOTE: To facilitate replacement of the display bezel, ensure that the camera connector is tucked in place beside the display panel before you snap the
bezel into place.
2. Replace the four M2.5 x 5-mm screws on the corners of the bezel.
3. Replace the four rubber bumper/screw covers around the bezel.
Display Panel

Removing the Display Panel

1 camera cable connector (present only
on computers with an optional camera)
2 M2 x 3-mm screws (4)
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface (such as the back
panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see
computer.
1. Follow the instructions in Before Working Inside Your
2. Remove the display assembly (see
3. Remove the display bezel (see
4. If an optional camera is present on the computer, disconnect the camera cable connector.
5. Remove the four M2 x 3-mm screws (two on each side of the display panel).
6. Remove the M2 x 3-mm ground screw that attaches the display-panel ground wire to the display back cover.
7. Turn the display assembly over so that the display panel is face down and the display hinges are toward you.
8. Lift the display back only enough to allow you to disconnect the speaker connector.
9. Lift the display back cover away from the display panel.
10. Remove the display-panel brackets from the display panel (see
11. Remove the cable assembly from the back of the display panel:

3 display panel

4 M2 x 3-mm display-cable
ground screw and ground
wire
Computer.
Removing the Display Assembly).
Removing the Display Bezel).
Removing the Display-Panel
5 display back
cover
6 speaker
cable
Before Working Inside Your
Brackets).
Computer) before working inside the