Display Bezel; Removing The Display Bezel; Replacing The Display Bezel - Dell XPS M1210 Service Manual

5. Reroute the display cable in the cable channel.
6. Reroute the antenna cables in their cable channel.
7. Replace the hinge cover (see
8. If any Mini-Cards are installed, connect the antenna cables to the card(s) (see Mini-Cards). If no Mini- Cards are installed, tuck the antenna cables into
their secured location.
9. Replace the communications card cover.
Display Bezel
1 rubber bumper/screw covers (4)
2 M2.5 x 5-mm shoulder screws (4)
5 hinge pins (2)

Removing the Display Bezel

CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see
computer.
1. Follow the instructions in Before Working Inside Your
2. Remove the display assembly (see
3. Remove the four rubber bumper/screw covers.
4. Remove the four M2.5 x 5-mm shoulder screws at the corners of the bezel.
NOTICE: Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel and the display panel.
5. Use your fingers to separate the bezel from the display back cover:
a. Starting at the center of the bottom of the bezel, lift the inside edge by pulling up and slightly downward toward the outside edge of the display
assembly to unsnap the bezel from the display back cover.
b. Repeat step a to release the snaps around the rest of the bezel and lift it away from the display panel.

Replacing the Display Bezel

1. Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the display panel.
Replacing the Hinge Cover).
3

display bezel

4 display back cover
Computer.
Removing the Display Assembly).
Before Working Inside Your Computer) before working inside the