Belt Routing - Kenmore 116.30012 Owner's Manual

BELT ROUTING
Correct Routing of Belt
(Selector in Carpet Position)
Carpet/Bare Floor Shaft
Selector Shaft
Agitator
Incorrect Routing of Belt
(Belt on Selector Shaft)
Floor Pedal
.,
Motor
Carpet/Bare Floor Shaft
Selector Shaft
Incorrect Routing of Belt
(Selector in Bare Floor Position)
Belt Carpet/Bare Floor
Selector Shaft
Press firmly, checking to see that each
end is completely inserted°
Agitator Assembly
Check to see that the belt is centered in
the belt groove,, Turn the agitator with your
fingers to see that it turns freely.
To re-attach the base plate, insert the
tabs into the slots along the front edge of
the base. Place the vacuum in full upright
position, Lower the base plate to its origi-
nal position.
Full Upright Position
Tab Locations
As the base is lowered the inner areas
will brush against the dust compartment
wheels° A gentle pull outward may assist
in reassembly.
Two Locking Tabs
Press the
base plate
down until
the two
locking tabs
snap into
place,
Slide the right
latch to the
right and the
left latch to
the left to
secu re.
Latches
Return the cleaner to the upright position
before plugging into the electrical outlet.
ue6nI
ns ua ugl_a
peplJn6as
ap sBla0gua!
Sel anb elseq
o[eqe eJed
o_,eldlap aseq
el auo!oaJa
'olJelq
un eleq el 'pn
Jo!Jalu! alJed I
le_!J
16
ns ue aseq
ug!o!sod el
el ap Felu(
se.mueJoqer
S_ I elJaSU! 'as