Trim Meter (Digital Type); Hour Meter (Digital Type); Trip Meter - Yamaha F150 Owner's Manual

Basic components
1. Cap
2. Selector switch (for speed unit)
3. Selector switch (for fuel sensor)
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best for
G
your boat under different conditions. Adjust
the trim angle to the desired using the pow-
er trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
22
EMU26650

Hour meter (digital type)

This meter shows the number of hours the en-
gine has been run. It can be set to show the
total number of hours or the number of hours
for the current trip. The display can also be
turned on and off.
Changing the display format
G
Pressing the "
es the display format in the following pat-
tern:
Total hours→Trip hours→Display off
Resetting the trip hours
G
Simultaneously pressing the "
"
ond while the trip hours are displayed re-
sets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26690

Trip meter

This gauge displays the distance the boat has
traveled since the gauge was last reset.
ZMU01740 Press the "
until the indicator on the face of the gauge
points to "
zero, press the "
buttons at the same time.
" (mode) button chang-
" (mode) buttons for more than 1 sec-
" (mode) button repeatedly
" (trip). To reset the trip meter to
" (set) and "
ZMU01741
" (set) and
" (mode)