Trim Meter (Digital Type); Hour Meter (Digital Type); Trip Meter - Yamaha 115 Owner's Manual

Basic components
power trim and tilt switch.
EMU26620

Trim meter (digital type)

This meter shows the trim angle of your out-
board motor.
NOTE:
Memorize the trim angles that work best
G
for your boat under different conditions.
Adjust the trim angle to the desired using
the power trim and tilt switch.
If the trim angle of your motor exceeds the
G
trim operating range, the top segment on
the trim meter display will blink.
EMU26650

Hour meter (digital type)

This meter shows the number of hours the
engine has been run. It can be set to show
the total number of hours or the number of
hours for the current trip. The display can
also be turned on and off.
24
Changing the display format
G
Pressing the "
G
es the display format in the following pat-
tern:
Total hours→Trip hours→Display off
G
Resetting the trip hours
G
Simultaneously pressing the "
G
and "
1 second while the trip hours are displayed
resets the trip counter to 0 (zero).
NOTE:
The total number of hours the engine has
been run cannot be reset.
EMU26690

Trip meter

This gauge displays the distance the boat
has traveled since the gauge was last reset.
Press the "
until the indicator on the face of the gauge
points to "
to zero, press the "
(mode) buttons at the same time.
ZMU01869
NOTE:
The trip distance is shown in kilometers or
G
miles depending upon the unit of measure-
ment selected for the speedometer.
The trip distance is kept in memory by bat-
G
tery power. The stored data will be lost if
the battery is disconnected.
ZMU01870
" (mode) button chang-
" (mode) buttons for more than
" (mode) button repeatedly
" (trip). To reset the trip meter
" (set) and "
" (set)
"