Table of Contents
Advertisement
WAILSLEEVE ADAPTER KIT
INSTALLATION INSTRUCTIONS
•
Unpack and dispose of packaging materials.
•
This kit retrofits the 111/2in. (29.2 cm) deep wall sleeve to
accept a replacement PTAC/PTHP requiring a 133/4in. (35 cm)
deep sleeve.
Wall Sleeve Adapter
Orientation
1. Install 2 screw clips over the holes on the top flange of the
wall sleeve with the flat side facing outward.
3. Fasten the adapter to the wall sleeve with 6 - #10 x 1/2in.
screws (provided), driving the screws from the inside of the
wall sleeve adapter into the screw clips mounted on the face
of the wall sleeve. The angle flange assists in properly
aligning the 2 parts.
4. Remove the protective paper from the foam insulation pieces.
Install the 2 short foam pieces on the short, inside walls of the
adapter. Install the long foam piece on the top, inside wall of
the adapter.
1
2=
1. Install screw clips.
4. Angle flange
2. Existing screw clips
5. Wall sleeve adapter
3. Wall sleeve
3
2
4
Insert the angle flange of the wall sleeve adapter over the
bottom flange of the existing sleeve. Align the top of the
adapter with the top surface of the existing wall sleeve.
1
2
1. Additional insulation pieces
2. Existing insulation
CHASSISINSTALLATION
2. Remove the 2 chassis shipping brackets from the ends of the
shipping pallet.
NOTES:
•
Check to be sure wall sleeve, wall sleeve extension (if used),
wall sleeve adapter (if used), rear grille, and drain kit are
properly installed before chassis installation.
•
Locate PTAC/PTHP near the location it will be installed.
IMPORTANT: Copper refrigerant tubes are not handles. Product
damage will occur if tubes are used to lift or move the chassis.
1. Remove banding and carton.
!. Compressor
2. Chassis shipping bracket
3. Shipping pallet
3. Remove the front cover, which is contained in a protective
plastic bag, from chassis.
4. Dispose of all shipping and packaging
material.
14
Advertisement
Table of Contents
