Table of Contents
Advertisement
STANDARDGRILLE INSTALLATION INSTRUCTIONS
NOTE: Unpack and dispose of packaging materials.
1. Remove the center support and weatherboard,
if still installed
in the wall sleeve.
4.
Grasp the grille by the attached plastic handles. Position it
with the condensate
drain knockouts facing down. From the
inside of the building, maneuver the grille through the wall
sleeve and pull toward you until the screw heads are inserted
into the keyhole slots at the top of the wall sleeve. Tighten the
2 screws.
2,
!. Wall sleeve
2. Weatherboard
3. Center support
Insert
6 plastic
grommets
into the outdoor
grille openings
from the outside
of the grille.
2
¸
5,
!. Plastic handles
2. Plastic grommets
3. Condensate drain knockouts
Insert the remaining screws into the remaining holes and into
the grommets and tighten all screws.
3,
1. Plastic handles
2. Plastic grommets
3. Condensate drain knockouts
Insert 2 - #8 x % in. sheet metal screws (provided) in the top
2 outside edge plastic grommets. Tighten the screws halfway
into the grommets.
12
Advertisement
Table of Contents
