Print A Network Status Sheet - Epson Stylus NX420 Series Quick Manual

Wireless network setup basic copying, printing, and scanning maintenance solving problems

Hide thumbs Also See for Stylus NX420 Series:

Basic operation manual (52 pages)

Start here (4 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

The printer does not appear in the Add Printer window (Mac OS X)

Make sure the printer driver was installed correctly and that your computer's

TCP/IP settings are configured correctly.

Cannot print over the network

■

Make sure that the printer is turned on and the green WiFi light on the front

of the printer is on.

■

When using TCP/IP, make sure the printer's IP address is set correctly for your

network. If your network does not assign IP addresses using DHCP, you need

to set the IP address manually.

Printing is slow or the print is cut off

Print a Network Status Sheet (see below) and check the signal strength. If it's poor,

try moving the printer closer to your wireless router or access point. Avoid placing

the printer next to a microwave oven, 2.4 GHz cordless phone, or large metal

objects such as a filing cabinet.

Cannot find the scanner or start Epson Scan

■

Epson Scan is not available in Mac OS X 10.6, see "Scanning with Mac OS X

10.6" on page 34 for scanning instructions.

■

If network communication was interrupted while starting Epson Scan, exit

Epson Scan, and restart it after a few seconds. If Epson Scan cannot restart,

turn the printer off and back on, and then try restarting Epson Scan. Check

the

Timeout Setting

Scan Help.

■

If you are scanning a large document at high resolution, a communication

error may occur. If the scan did not complete, lower the resolution.