Assembling The St-4500 - Korg Concert C-4500 Owner's Manual

Assembling the ST-4500

Use two or more people to assemble the stand.
When placing the piano on the stand, be careful not to
pinch your hand.
Be sure that the correct parts are assembled in the
correct orientation, and follow the steps in the order
that they are given.
If you apply weight to the front edge of the piano
before tightening the screws, the piano may fall down.
1. Open the packing carton and remove the
contents.
Check that all of the following items are present.
• Rear Panel 4
• Pedal Box 3
• Side Panel
(Left) 1
• In the plastic bag
• Long screws 4 • Adjuster
5
(M6 x 16)
• Adjustable bolts 2
8
Caution
• Side Panel
(Right) 2
• Short screws 10
6 7
(M3.5 x 16)
• Cable holder
9
2. Attach the side panel (left) 1 and side panel
(right) 2 to the pedal box 3, and use four long
screws 5 to fasten them.
5
3
1
3. Attach the back panel 4.
Use four short screws 7 to fasten the bottom edge
of the back panel 4, and four screws 8 to fasten
the sides. Use one short screw 7 to fasten the
cable holder to the back panel.
• Finished surface toward the front.
4
• Fasten the cable holder 9 together with the back panel.
At this time, make sure that there are no gaps in
the stand, and that it does not tilt.
4. Attach the piano.
Place the piano on the stand so that the plastic feet
on the bottom of the piano fit into the holes in the
side panel brackets. From below, use four adjust-
able bolts 0 to fasten the piano to the stand.
8
Rotate the adjuster so that it firmly contacts
the floor. If the adjuster is not in firm
contact with the floor, the pedal may wobble
and cause malfunctions.
2
•
Pull out the Pedal Cord.
•
Screw the Adjuster 6 into the Pedal
Box 3 until it is all the way in.
7
8
25