BOXLIGHT 9000-INT Manual page 8

S a f e t y
NOTE: If you open the projector
case, you will void the warranty.
iv
S u m m a r
Grounding
The projector is grounded through the grounding conductor on
the power cord. To avoid electric shock, plug the power cord into
a properly wired receptacle. Do not defeat the purpose of the
grounding-type plug.
Lamp
To avoid overheating and unacceptable image quality, replace the
projection lamp with a lamp of the specified type. Refer to
page 45 for lamp specifications and to page 37 for instructions on
replacing the lamp.
Lamp Compartment
To avoid burns, do not open the lamp module door until the pro-
jector is turned off and the lamp has cooled for at least 30 min-
utes. Follow the instructions in this manual for lamp replacement
carefully.
Hot Surfaces
Allow the projector to cool at least 30 minutes before replacing a
lamp. When you open the lamp housing, be very careful not to
touch the hot surfaces inside.
Ventilation and Overheating
Openings in the projector case provide ventilation to protect it
from overheating. Keep loose papers and other objects well away
from the grills. Do not place the projector on top of or close to a
computer or other heat-producing equipment.
Liquid Spills
Do not set drinks on top of the projector. Spilled liquids can flow
inside and cause damage.
Do Not Disassemble
All service must be performed by Boxlight. The only user-service-
able parts in the projector are the projection lamp, which you can
replace by opening the lamp cover on the side of the projector
(see page 37) and the fan intake filter (see page 35). Do not open
any other part of the projector.
y