Connecting A Video Player - BOXLIGHT 9000-INT Manual

S e t t i n g
NOTE: For model 9000-INT: To
use video input, an optional video
board must be installed in the
projector. Contact Boxlight for
more information.
14
u p t h e

Connecting a Video Player

1 If your video player uses a round, one-prong composite video
connector, you'll need only the A/V cable that shipped with
the projector. (Refer to Figure 14 on page 16 to see the connec-
tor types.)
If your video player uses a round, four-prong S-video con-
•
nector, you'll need an S-video cable in addition to the A/V
cable. If your video player uses a BNC connector, you'll
need a BNC cable in addition to the A/V cable. The cables
are sold separately. (See "Optional Accessories" on
page 47.)
2 Plug the A/V cable's yellow connector into the "video-out"
port on your video player. This port may be labeled "To Moni-
tor."
If you're using an S-video cable, connect it to the "s-video
•
out" connector on the video player. If you're using a BNC
cable, connect it to the BNC connector on the video player
(Figure 12).
3 Plug the other yellow connector into the composite connector
on the back of the projector (labeled
If you're using S-video or BNC, plug the other end of the
•
cable into the "S-VID" or "BNC" connector on the projector
(Figure 12).
F 12
IGURE
Connecting the projector to a video player using an S-video cable and the audio con-
nectors on the standard A/V cable
P r o j e c t
S-video cable
A/V cable
o r
under Video 2).