Connecting The Remote Control Cable; Connecting A Computer With An Rs-232 Cable; Powering Up The Projector And Adjusting The Image - BOXLIGHT 9000-INT Manual

S e t t i n g
NOTE: For more information on
using the remote, see page 21.
NOTE: Always use the power cord
that shipped with the projector.
16
u p t h e

Connecting the Remote Control Cable

If the projector cannot receive the remote's signal, as may be the
case if you're using rear projection, connect the remote directly to
the projector with the remote cable.
1 Plug the remote cable into the
2 Plug the other end into the connector on the remote.
F 14
IGURE
Connecting the remote control cable

Connecting a Computer with an RS-232 Cable

You can control the projector from an LCD control panel by con-
necting an RS-232 cable to the projector (see Figure 8 on page 10).
See "RS232 Terminal Specifications" on page 57 for details.

Powering up the Projector and Adjusting the Image

1 Remove the lens cap.
2 Plug the power cord into the side of the projector, then plug it
into your electrical outlet. A surge-protected power strip is
recommended if power surges are common in your area.
3 Turn on the projector by pressing the power button on the
remote or keypad.
The startup screen displays.
•
P r o j e c t o r
connector on the projector.