Table of Contents
Advertisement
UTILITY STITCHES — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Basic Stitching
Straight stitches are used for sewing plain seams. Three stitches are available for basic stitching.
Stitch Name
Basic stitching,
J
sewing gathers or
Left
pintucks, etc.
Attaching zippers,
basic stitching, and
J
Center
sewing gathers or
pintucks, etc.
Attaching sleeves,
sewing inseams,
Triple stretch
J
sewing stretch fab-
stitch
rics and decorative
stitching
1
*
Do not use reverse stitching.
The values below "Auto" are set when the pattern is selected. The setting can be adjusted to any value within the range
indicated below "Manual".
CAUTION
● Before replacing the presser foot, be sure to turn off the sewing machine, otherwise injuries may occur
if a button is accidentally pressed and the machine starts sewing.
a
Baste or pin together the fabric pieces.
b
Turn on the machine.
c
With the pattern selection dial,
select
,
or
d
Attach zigzag foot "J".
• For details, refer to "Replacing the presser
foot" (page 31).
e
If reverse stitches are to be sewn, lower the
needle into the fabric 3 to 5 stitch lengths in
front of the point where the stitching will
begin, and then sew the reverse stitches.
• For details, refer to "Securing the stitching"
(page 44).
f
Start sewing.
• For details, refer to "Starting to sew"
(page 42).
If reverse stitches are to be sewn at the end of
g
stitching, sew 3 to 5 reverse stitches.
• For details, refer to "Securing the stitching"
(page 44).
54
Stitch Width
[mm (inch)]
Application
Auto
0.0
(0)
3.5
(1/8)
0.0
(0)
.
Stitch Length
[mm (inch)]
Manual
Auto
Manual
0.0–7.0
2.5
0.2–5.0
(0–1/4)
(3/32)
(1/64–3/16)
0.0–7.0
2.5
0.2–5.0
(0–1/4)
(3/32)
(1/64–3/16)
0.0–7.0
2.5
1.5–4.0
(0–1/4)
(3/32)
(1/16–3/16)
h
When sewing is finished, cut the thread.
■ Changing the needle position
The needle position can be adjusted with the
straight stitch (left needle position) and the triple
stretch stitch by adjusting the stitch width. Press
the "–" side of the stitch width key for a left
needle position, or press the "+" side for a right
needle position.
a
c
a Stitch width
b Stitch width key
c Moves the needle position to the left
d Moves the needle position to the right
Walk-
Reverse/
ing
Reinforcement
Foot
Stitching
Yes
1
*
Reverse
(J)
Yes
Yes
1
*
Reverse
(J)
Yes
Yes
No Reinforcement
(J)
b
d
Hide quick links:
Advertisement
Table of Contents
