Preparing For Upper And Lower Threading; Winding The Bobbin - Baby Lock BL50A Instruction And Reference Manual

Preparing for Upper and Lower Threading

Winding the bobbin

Wind the thread onto the bobbin.
CAUTION
● Only use the bobbin (part code: X52800-120) designed specifically for this sewing machine. Use of any
other bobbin may result in injuries or damage to the machine.
● The included bobbin was designed specifically for this sewing machine. If bobbins from other models
are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same
type (part code: X52800-120).
a Turn on the sewing machine.
b Place the bobbin on the bobbin winder shaft
so that the spring on the shaft fits into the
notch in the bobbin.
a Notch
b Bobbin winder shaft spring
c Slide the bobbin winder shaft to the right until
it snaps into place.
c
a
a
b
a This model
b Other model
c 11.5 mm (7/16 inch)
(actual size)
b
d Swing up the spool pin, and then remove the
spool cap.
b
a Spool pin
b Spool cap
e Fully insert the spool of thread for the bobbin
onto the spool pin.
Slide the spool onto the pin so that the spool is
horizontal and the thread unwinds to the front
at the bottom.
a Hook of the
bobbin-winding
thread guide
b Pretension disk
c Bobbin winder
shaft
d Bobbin
a
15
1