Table of Contents
Advertisement
Check Calibration
Tools: Digital thermometer with probe; oven mitt.
See also, Temperature Calibration on page 12.
1. Clamp the probe in the center of the middle rack.
2. Pass the probe wire out of the oven between the
door and the door seal and close the door.
3. Plug the probe wire into the thermometer.
4. Press the oven On/Off button.
5. Press the "Preheat Bakery 350" button to heat
the oven to 350°F. Allow the oven to preheat for
approximately 30 minutes before calibrating.
Break in Period
When the oven is new, heat the oven to "Preheat
Bread 425), and leave the oven idle for one hour before
beginning normal operation.
Oven Cleaning
Exterior
• NOTE: Disconnect the oven from the power supply
before cleaning or servicing.
• Establish a regular cleaning schedule. Any spills
should be wiped off immediately.
Tools: Mild detergent; hot and warm water; sponge
or soft cloth; clean, dry cloth; possible non-metallic
scour pad; possible scouring powder.
Page 14
CLEANING AND MAINTENANCE
1. The oven should be allowed to cool sufficiently
before beginning the cleaning procedure.
2. Wipe exposed cleanable surfaces when cool with
a mild detergent and hot water. Stubborn residue
spots may be removed with a lightweight non-
metallic scouring pad. Dry thoroughly with a clean
cloth.
3. Painted surfaces should be cleaned using a mild
soap and warm water solution on a sponge or soft
cloth. Dry thoroughly.
4. Stainless Steel surfaces may also be cleaned using a
mild soap and warm water solution on a sponge or
soft cloth. Stubborn stains may be removed using a
non-metallic abrasive pad, rubbing in the direction
of the metal's grain. If necessary, for particularly
heavy spots, you may mix a thin paste of water and
scouring powder, and apply it with a sponge. Be
careful to apply light pressure and remember to rub
only in the direction of the metal's grain.
5. The control panel surface is easily cleaned with
hot water, soap, and a soft cloth. Do not use
hard abrasives, solvent type materials, or metallic
scouring pads since these will scratch and cloud the
surface.
6. Never spray the perforated areas or control panel
with steam or water as this will allow moisture
to enter the control cavity, which could damage
electrical components.
Part # 4518084 Rev. 1 (09/04)
Advertisement
Table of Contents
